AND PLEASE SUBSCRIBE TO MY CHANNEL TO WATCH NEW ORIGAMI VIDEOS: Check out other Origami Videos: Butter Fly: Swan: Paper Boat: Paper Flower: Water Bomb (Paper Ball): ALSO CHECK OUT MY PLAYLIST: Please write me your voluble views and do not forget to share to your friends. I also like you to visit different other paper origami videos uploaded on my channel. I hope you will enjoy making beautiful origami and impress your friends. So watch and learn this wonderful paper folding craft. Folding a paper and making origami is a challenge for beginners but this origami making video tutorial will make you expert and making paper origami will be very easy for everyone. I suppose the non-crease folds tend to be somewhat smoother, and the model holds its shape better, but if I was hoping to use wet-folding to facilitate folding through thick sections in complex models, I am bound to be disappointed unless I can significantly improve my technique.Ĭonclusion: Next time I should try using a spray bottle, a ruler and exacto knife, and a clean, non-absorbent hard surface, and maybe I’ll be able to make a better elephant.Learn How to make Origami Elephant. And furthermore, re-dampening a semi-3D elephant with a wet kleenex is hard. That is, too quickly to finish folding a (simple) elephant. Wet origami paper does hold creases (I’d been rather suspicious that it wouldn’t at all), but they become very hard to see after a while.In this condition, I started folding the elephant, completely botching the folds leading up to the tusks, which in turn made even my makeshift tusk-fold impossible (I sort of skipped that part, just twisting the tusks into existence, which seemed to work, more or less). Of course, the more I tried to wipe off the dirt, the more color I lost… It turns out that wet paper picks up a lot of dirt. My (unvarnished) wooden table-top is much dirtier than I had thought.I could swear I ended up with almost as much color on the tissue I was using to wet the paper as on the paper itself. The color on the paper is water-soluble.Good thing the pattern didn’t require much precision. But I was afraid it would dry out if I wasted time trying to trim it, so I just ignored it, and did all of my folds to within a 1/6 inch error. Like, really not square, with a difference of maybe a third of an inch (out of seven inches) between the two directions. If it’s wet equally on both sides it doesn’t wrinkle much out of the plane, but in the plane it expands different amounts along different axes when wet. The paper I’ve been using has a grain–most of the fibers run in the same direction.As I tried to manipulate the paper I noticed a couple of things: So I took the advice of Wikipedia and wet both sides of a piece of paper using a damp kleenex, to ready it for wet-folding (using, of course, the same type and size of paper as before, albeit of a different color). The model, however, only gives the general 3D shape of an elephant, requires a certain amount of paper-sculpting at the end, which is hard to do with normal paper. The hand-drawn instructions failed me when they tried to describe the fold for the tusks, but I made something up, which seemed to work. So first I folded it in the usual way (i.e. So I decided that the African Elephant would be a good place to start, partly because the pattern (although tricky) doesn’t have very many folds overall (and doesn’t require any particularly precise folding), and partly because the instructions suggested it. In my last (and first) post I said I’d try wet-folding, because some of these models seem to require either thinner or more malleable paper.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |